|
| |
Bungee
Sled facility [ For type approval tests
& to evaluate seats, seat belts &
its anchorages. ] |
| |
|
16 channels
on board data acquisition system
|
|
Speed
measurement system |
|
 |
Two
high speed off board cameras with maximum
capability of 10,000 frames per second
and motion analysis software |
|
High
intensity metal halide lighting with a
maximum power output 64 kW and lighting
intensities up to 1.0 lac lux. |
|
Three
non- instrumented (TNO-10) dummies. |
|
G-lock
test rig evaluates the performance
of the retractor and seat belt anchorages
with advanced digital controllers for
synchronous application of commissioned
load. |
|
|
Custom built 4-poster rig with RPCIII software is intended for vehicle simulation on 4 wheel vehicles. It is possible to carry out road load simulation of 4 wheel vehicles up to 250 kN GVW, and 2 and 3 wheelers with actuators. The control system permits simulation, control with 16 x 16 square and non square matrices. |
|
Multi- Axis Simulator, two corner system consists of front and rear spindle mounted fixtures that produce vertical, longitudinal and lateral forces through the front and rear spindles for two-wheeler and left and right hand spindle for four- wheeler. This system facilitates manufacturers in the development of the vehicles in following areas: |
|
| |
|
|
|
Ride comfort Analysis |
|
Evaluation of suspension |
| |
|
Frame dynamic behaviour |
|
|
|
Vibration tests |
|
|
This system
enables evaluation of suspension
systems for half-car performance
and durability tests on the suspension
assembly. Simultaneous development
of suspension is possible, even
when the complete vehicle is not
ready. |
|
|
It is
the first
such facility in India. |
|
Rotary
Actuator enables to evaluate torsional
stiffness, durability of axle shafts,
propeller shafts, UJ coupling for Heavy
Commercial Vehicles / earth moving equipments. |
|
|
Comparative
evaluation of chassis frame
by fatigue testing in bending and
torsion mode |
|
|
|
|
Software
for analysis and control |
| |
|
|
n
Soft from Code International for
statistical, frequency, coherence, fatigue,
correlation, signature, Powertrain analysis
and fracture mechanics. |
|
RPC-III
with Flextest from MTS, USA for
remote parameter control for simulations
up to 16 x 16 square and non square matrices,
geometric compensation, life prediction,
rig control simulation, statistical, frequency
and coherence analysis. |
|
Reflective
photo-elastic equipment from Measurement
Group, USA assists to visualize the stress
pattern, identificatin of critical areas
and quantification of local stresses on
various components under static / dynamic
loads. |
|
|
|
| |
